GE Current Lumination IS Series Installation Manual page 6

Wiring Diagrams
DALI 0-10V
Fixture
Fixture
Black
Line
White
Neutral
Neutral
Ground Green Ground
DALI Violet/White
(0-10V)+
DALI Violet
(0-10V)–
3
Pull out continuous wiring
6
Pull the continuous wiring out of the luminaire being mounted and slide the bridge of the luminaire down onto the bridge of the
already installed luminaire so that the tabs and slots at top and bottom nest into one another. The bridges will engage with a
loud click when fully mated.
7
Connect the power and control
connectors of the through wiring
harness.
10
Replace the PSU cover(s) and secure
using the mounting screws.
Note: When installation is complete,
all lead wires and connectors shall be
totally enclosed.
Previously
hung unit
Black
Line
White
Green
Violet
Grey
4
Toadd a continuous unit to a continuous
run, first suspend the new unit as it is done
in steps 9 and 10 for the independent unit.
Position the non-power-supply end of the
luminaire near the power-supply end of
the previously hung luminaire.
Align tabs
with slots
8
At the beginning of the row, push the
wiring inside the cavity of the bridge.
New unit
5
5
9
6
Remove the PSU cover from the
previously hung luminaire if present.
Push down
to engage
Clip one end-cap at the beginning
of the row and one at the end
(provided in the starter kits).