GE Current Lumination IS Series Installation Manual page 4

3
Prepare luminaire for installation
by loosening the PSU cover screws
and removing the cover.
ACline
6
Connect the green (ground), black
(line) and white (neutral) wires of
the ACline to the similarly colored
wires of the power supply unit using
separate UL listed wire nuts.
9
Fix the mounting position and secure
the suspension by tightening the two
screws on both mounting brackets.
4
For 347V ftxture: Loosen PSU cover
screws and remove two covers.
Dimming line
(optional)
PSU
wires
7
Optional dimmer: Install UL listed
electrical fitting and insert dimming
control wires through. Connect
dimming control wires (grey and violet
for 0-10V or violet and violet/white strip
for DALI) to the similarly colored fixture
wire using separate UL listed wire nuts.
10
Replace power supply cover(s) by
sliding over the captive screws and
secure by tightening them.
Note: When installation is complete,
all lead wires and connectors shall
be totally enclosed.
5
Dimming
wires
8
4
ACline
Carefully remove appropriate knockout
for AC line input wires (inner knockout
for ½" conduit, outer knockout for
¾" conduit). Install listed electrical
fittings in the knockout holes for wire
protection and pass supply conduit
through electrical fittings.
Clip luminaire to the previously
installed mounting brackets.
Wiring Diagrams
DALI 0-10V
Fixture Fixture
Black
Line
Line
White
Neutral
Neutral
Ground Green Ground
DALI Violet/White
(0-10V)+
DALI Violet
(0-10V)–
Black
White
Green
Violet
Grey