GE Current Lumination IS Series Installation Manual page 15

Troubleshooting
Symptom
Luminaires will not turn on
Luminaire on through wiring
will not turn on
Luminaire to luminaire mating
in continuous run is loose
Suspension methodwon't
engage with luminaire
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause undesired operation. This Class [A] RFLD complies with the
Canadian standard ICES-003. Ce DEFR de la classe [ A ] est conforme à la NMB-003 du Canada.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCCRules. These limits are
designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
www.LED.com
GE and the GE Monogram are trademarks of the General Electric Company. All other trademarks are the property of their respective owners. Information
provided is subject to change without notice. All values are design or typical values when measured under laboratory conditions. GE Lighting is a business of the
General Electric Company. ©2019 GE.
IND095-SPA-(Rev04/15/19)
GE2024-6981
Solution
• Check that the color of the supply side wires match the color of the wires they are connected to.
• Check that the LED driver connector is fully engaged to the LED light engine connector.
• Check that the through wiring connector from the previous fixture in the linear row is fully
engaged to the malfunctioning luminaire.
• Ensure that both upper and lower connecting features are correctly engaged.
• Ensure that through wires are correctly routed in the wiring notch.
• Check that the suspension method is one of the approved types in the installation instruction.
15