Installing Contact Tip And Nozzle - Hobart Welding Products Handler 125 Owner's Manual

5-8. Installing Contact Tip And Nozzle

3
2
1
!
Turn off welding power source.
1 Nozzle
Remove nozzle.
Notes
Tools Needed:
MIG Nozzle
Use with solid or flux cored wire.
Push nozzle over contact tip and
adapter until it is seated onto
adapter. End of contact tip will be
flush with end of nozzle when
installed properly.
2 Contact Tip
3 Tip Adapter
Thread welding wire through gun
(see Section 5-9).
Flux Nozzle (Optional)
Use with flux cored wire only. Narrow
design allows access in tight spaces
and provides better visibility of puddle
during welding.
Push nozzle over contact tip and adapter
until it is seated onto adapter. Contact tip
will be exposed approximately 7/16 in.
(11.3 mm) when installed properly.
Slide contact tip over wire and tighten tip
into tip adapter.
Install nozzle.
Work like a Pro!
Pros weld and cut
safely. Read the
safety rules at
the beginning
of this manual.
OM-283007 Page 15
Ref. 804241-A