Section 5 − Installation; Installing Nozzle, Contact Tip, And Adapter; Installing Welding Gun - Hobart Welding Products Handler 210 MVP Owner's Manual

5-1. Installing Nozzle, Contact Tip, And Adapter

1
Tools Needed:
8 mm

5-2. Installing Welding Gun

Spool Gun
É É É
É É É
É É É
É É É
6
MIG Gun
.
Be sure that gun end is tight against drive assembly.
Incorrect
Gun Not Seated
SECTION 5 − INSTALLATION
2
3
8 mm
1
3
3
Exposed O-rings
will cause shielding
gas leakage.
Head
Tube
5
2
4
Correct
Gun Fully Seated
! Turn off welding power
source.
1 Nozzle
2 Contact Tip
3 Tip Adapter
.
Wire size stamped on tip − check
and match wire size.
Ref. 243 839-A
1 Drive Assembly
2 MIG Gun
3 Gun Securing Thumbscrew
4 Gun End
Loosen thumbscrew. Insert end
through opening until it bottoms
against drive assembly. Tighten
thumbscrew.
Welding gun must be inserted
completely to prevent leakage of
shielding gas.
5 Gun Trigger Plug
Insert plug into receptacle, and
tighten threaded collar.
6 Spool Gun/MIG Gun Switch
Place switch in MIG Gun position.
Close door.
3
OM-249 498 Page 15
804 695-A