Table of Contents
Advertisement
Tools required to convert this grill from Propane Gas to Natural Gas (tools not provided):
1. # 2 Phillips screwdriver
2. 7 and 9 mm wrenches
The NG conversion kit is supplied with this grill:
Item
1
NG Orifice, Main Burner: #53 drill size
NG Orifice, Rotisserie Burner: #53 drill size
2
The outdoor gas appliance and its individual shut off valve must be disconnected from the
gas supply piping system during any pressure testing in excess of ½ psi (3.5 kPa).
The outdoor gas appliance must be isolated from the gas supply by closing it s individual
manual shut off valve during any pressure testing of the gas supply piping system a t test
pressures equal to or less than ½ psi (3.5 kPa).
MAIN BURNER CONVERSION
1.
Remove the cooking grids and flame diffusers.
2.
Remove the cotter pins that hold the main burners to the firebox rear wall.
3.
Using a 7 mm wrench undo all of the main burner orifices from the underside of the control panel.
4.
After all the propane orifices are removed from the grill place them in a safe spot away from your
work area. This will ensure you do not re-install the propane orifices.
5.
Using an approved thread sealant, replace the main burner orifices with the NEW natural gas
orifices supplied.
6.
Before reinstalling the main burners make sure to close the air shutter on each burner half of what it
is set for prop ane use. When reinstalling the ma in burners ensure that the burner is properly
placed over the main burner orifice and reinstall the main burner cotter pin on the firebox rear wall.
7.
Reinstall the flame diffusers and cooking grids.
NATURAL GAS CONVERSION
Description
11
Quantity
3 pcs
1 pc
Advertisement
Table of Contents
