Control Wiring - ViewSonic PJ862 Quick Start Reference Sheet

Hide thumbs Also See for PJ862:

SmartPanel Projector Driver Application Note

II. CONTROL WIRING

PROJECTOR CONTROL

RS232

5 4 3 2 1

Female DB9

9 8 7 6

RS-232 to

CONTROL

This section specifies how RS-232 and Infrared should be

wired to the ViewSonic projector.

A. RS-232 should be connected to the female DB9

IR/SERIAL

terminal labeled CONTROL. Connection should be as

follows:

1. Wire the Panel to a female DB9 as follows:

2. Connect this female connector to the projector port

labeled CONTROL.

1/8" Mini

B. The IR Emitter should be connected to the one of the

Female

ViewSonic IR windows as follows:

1. Wire the Panel to a female 1/8" Mini as show; wire

IR/SER to tip and GND to ring. Splicing and direct

wiring to the IR Emitter is not recommended as it

makes removal of the Panel for service more difficult.

2. Connect the included IR Emitter to the female mini.

3. Affix the IR Emitter to one of the IR windows on the

projector.

Note that the emitter glows red when IR is emitted so wiring

can be verified.

IR Emitter to

any IR window

TX to 2

RX to 3

GND to 5

ViewSonic PJ862

help@spcontrols.com

Table of Contents