Table of Contents
Advertisement
OPERATING THE TOOL
1)
Remove plastic air inlet protective cap from air inlet as shown
in Fig.4.
2)
Prepare a 1/4" male plug (not included) by applying sealant
tape to the threading, wrapping clockwise. Screw threaded
male air plug by hand into air inlet as shown in Fig.5 and
tighten it with a wrench (not included) for an airtight connec-
tion. Note: Do not overtighten! Sealant tape must be used
on this connection.
3)
Push the control valve forward so that the end of the valve
protrudes out above the trigger for a clockwise ("forward") tool
operation.
4)
Push the control valve back so that the end of the valve pro-
trudes from the back of the housing for counterclockwise ("re-
verse") tool operation.
5)
Adjust the air flow by pushing down the air regulator and turn-
ing knob from positions 1 to 4 (Fig.2), aligning the desired
number setting with the recessed arrow.
Position 1 allows the lowest amount of air flow.
Position 4 allows the highest amount of air flow.
6)
Push and snap the required 1/2" drive impact socket (not included) onto the anvil.
CAUTION:
Keep tool pointed in a safe direction at all times.
Only use impact rated accessories with this tool. Other accessories may shatter, chip
or crack during operation.
Clean and inspect the tool daily. Carefully check for proper operation of trigger and
safety mechanism. Do not use the tool unless both the trigger and safety mechanism
are functional, if the tool is leaking air or needs any other repair.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Seite 25
Advertisement
Table of Contents
