Regular Maintenance - WilTec 61134 Operation Manual

MAINTENANCE

REGULAR MAINTENANCE

Clean and inspect the tool daily. Make sure the tool is disconnected from the air supply.

Blow the tool clean with compressed air and inspect for wear and damage. Use non-flammable

cleaning solutions to wipe the exterior of the tool, only if necessary. DO NOT SOAK the tool with
cleaning solutions. Such solutions can damage internal parts.
Inspect the trigger and the safety mechanism to ensure the system is complete and functional.

Check for loose or missing parts as well as parts that may be stuck.
Keep all screws tight. Loose screws may cause personal injury.

Place two or three drops of pneumatic oil (included) into the air inlet of the tool daily.

BEFORE EACH USE inspect the general condition of the tool. Check for:

Loose hardware or housing
o
Misalignment or binding of moving parts
o
Cracked or broken parts
o
Any other condition that may affect its safe condition
o
Daily – Air supply Maintenance: Every day, maintain the air supply

according to the component manufacturers' instructions. Maintain the
lubricator's oil level. Drain the moisture filter regularly. Performing rou-
tine air supply maintenance will allow the tool to operate more safely
and will also reduce wear on the tool.
Weekly – Lubrication: Add a high quality machine oil to the oil inlet by

removing the oil screw (Fig.7)
Quarterly (every 3 months) tool disassembly, cleaning and inspection: Have the internal

mechanism cleaned, inspected and lubricated by a qualified technician.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Seite 26