Preparing The Tool - WilTec 61134 Operation Manual

Air fitting: The 1/2" air impact wrench should be equipped with a 1/4" NPD male quick connector

(not included). To prevent accidental cycling even though disconnected, the tool must always be
connected to the air supply in a ways that all air pressure within the tool is released when the cou -
pling is disconnected.
CAUTION:
All air pipe components (including hoses, pipe, connectors, filters, regulators etc.)

must be rated for a working pressure of 90 psi.
Disconnect the tool from the air supply before performing maintenance, leaving the

work area, moving the tool to another location or handing it to another person.

PREPARING THE TOOL

Drain water from the air compressor tank and any condensation from air lines. (Please refer to the op -
eration manual of the air compressor)
Lubricate the tool. (Please refer to the maintenance section in this manual)

Select the necessary impact sockets. The sockets must match the size of the drive on the air im-

pact wrench.
Connect air impact wrench to the air source using the recommended hose size.

CAUTION:
Keep tool pointed away from yourself and any other person at all times.

Never use a tool that leaks air or needs repair.

© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Seite 24