Table of Contents
Advertisement
TOOL USE AND CARE
Get to know this tool. Read the manual carefully, learn its application and limitations, as well as
the specific potential hazards related to this tool.
Do not force the tool. Use the correct tool for the application. The correct tool will do the job better
and safer at the rate for which it has been designed for.
WARNING! Disconnect the tool from the air source before making any adjustments, changing acces-
sories or before storing the tool. Such precautionary measures reduce the risk of injury to persons.
Check for misalignment or binding of moving parts, breakages and any other conditions that may
affect the tool in its operation and safety. Damaged tools must be repaired before using them.
Many accidents are caused by poorly maintained tools. There is a risk of bursting if the tool is
damaged.
Store the tools in a secure place when not in use and keep them out of reach of children and other
untrained persons. A tool is dangerous in the handy of untrained users.
Holding a work piece by hand or against the body is unstable and may lead to loss of control.
Keep the tool and its handle dry, clean and free from oil and grease. Always use a clean cloth
when cleaning it. Never use brake fluids, gasoline, petroleum-based products or any strong sol-
vents to clean your tool.
Do not use the tool as hammer.
Never use gasoline or flammable liquids to clean the tool. Never use the tool in the presence of
flammable liquids or gases. Vapors can be ignited by a spark and cause an explosion that will re-
sult in death or serious personal injury.
Do not remove or manipulate the trigger. Never cause the trigger lock to become inoperable. Do
not operate any tool which has been modified in any way. Death or serious personal injury can be
the result.
Never use the tool if the switch does not work. Any tool that cannot be controlled by the switch is
dangerous and must be repaired before using it again.
Always fit the tool with a fitting or hose coupling on or near the tool that all compressed air is dis-
charged at the same time when the fitting or hose coupling is disconnected. Do not use a check
valve or any other fitting that allows the air to remain within the tool. Death or serious personal in-
jury might be the result.
Never carry the tool by the air hose or pull the hose to move the tool away from a compressor.
Keep hoses away from heat, oil and sharp edges. Replace any hose that is damaged, weak or
worn. Otherwise this might result in personal injury or damage to the tool.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Seite 20
Advertisement
Table of Contents
