Removing and installing the battery
Battery
Notes
Only use batteries approved by Fujitsu Siemens Computers for your notebook.
Never use force when inserting or removing a battery.
Make sure that no foreign bodies get into the battery connections.
Removing the battery
► Switch the notebook off and pull the power plug out of the mains socket.
Battery
► Close the LCD screen so that it locks into place.
► Disconnect all cables connected to the notebook.
► Turn your notebook over and place it on a stable, flat and clean surface. If necessary, lay
an anti-slip cloth on this surface to prevent the notebook from being scratched.
► Slide the battery release in the direction of the arrow (1) and hold it in place.
The battery release is unlocked.
► Slide the hard disk carrier in the direction of the arrow (2) as far as it will go.
A red field appears on the battery release.
► Slide the battery release in the direction of the arrow (1) again and hold it in place.
► Tilt the battery on the red field of the battery release to one side and lift
it out of the battery compartment (3).
A26391-K225-Z120-1-7619, edition 1
1
3
2
Ports and operating elements
15