Table of Contents
Advertisement
Installing the hard disk
► Insert the hard disk into the hard disk carrier.
► Fasten the hard disk carrier with the screws (1).
► Insert the hard disk at an angle into the hard disk compartment (1). Ensure that the eyelet
(a) on the hard disk holder is inserted correctly into the existing opening.
► Place the hard disk in the hard disk compartment (2).
► Pull the hard disk by the pulling aid (b) in the direction indicated by the arrow (3) until
the hard disk can be felt to latch into the hard disk connector.
If the pulling aid (b) sticks out too far from the hard disk, it will not be
possible to fasten the hard disk cover correctly.
► Lay the pulling aid (b) down flat on the hard disk.
A26391-K225-Z120-1-7619, edition 1
Removing and installing components during servicing
1
1
a
1
1
1
b
2
3
23
Advertisement
Table of Contents
