Microreel System Components; Assembly; Camera Head Routing - RIDGID SeeSnake microReel Manual

SeeSnake

microReel System Components

Shoulder Strap
Pushrod
Guide
CountPlus
Keypad
Front Case
Figure 1 – Front View (SeeSnake Configuration)
microEXPLORER
Camera Monitor
microEXPLORER
Camera Monitor
Cradle
System Cable for
microEXPLORER
Camera Monitor
Case Latch
Feet
Figure 2 – Rear View (microEXPLORER Camera Monitor
Configuration)
6
® microReel Inspection System
System Cable for
SeeSnake CCU
Case Latch
Camera Clip
Camera Head
Feet
microEXPLORER
Camera Monitor
Connector Plug
Cord Wrap
Rear Case
Slip Ring Module
Ridge Tool Company
Pushrod
Removable
Pushrod Drum
Camera
Head
Figure 3 – Opening The Case

Assembly

WARNING
To reduce the risk of serious injury during use, follow
these procedures for proper assembly.

Camera Head Routing

1. Set the unit on a level surface laying it on its side.
2. Unfasten the case latches on either side of the
microReel (Figure 4).
Figure 4 – Unlatching the microReel Case
3. Open the case carefully and only far enough to slip
the camera out through the cable guide. When rout-
ing the camera head out through the cable guide be
careful to avoid letting the pushcable spring out of
the drum or uncoil freely. Close the case and secure
the camera head in the provided clip.