Table of Contents
Advertisement
Problem solving guide
Message
lights up yellow in
the display and an
alarm also sounds.
The symbol lights up
in the display and an
alarm sounds.
62
Cause and remedy
The ice cube drawer is not in the refrigeration appli-
ance. A buzzer sounds after closing the appliance
door
Touch in the display.
The alarm message is confirmed and the buzzer
stops.
The current temperature will appear in the display
again.
Replace the drawer correctly or switch the ice
cube maker off.
The mains water connection has not been installed.
Make sure that the mains water connection has
been installed correctly.
The water supply is turned off.
Open the tap.
There is a kink in the stainless steel hose.
Check the stainless steel hose; if it is faulty, it must
only be replaced by an original Miele spare part.
The water connection pressure is too low.
Check that the water connection pressure is
between 150 kPa and 600 kPa (1.5 bar and 6 bar).
You have selected the "Cleaning position " func-
tion, and the appliance has detected that the ice cube
drawer is full. The selected procedure is interrupted
and an alarm has sounded.
Touch in the display.
The alarm message is confirmed and the warning
tone stops.
The current temperature will appear in the display
again.
Empty the drawer, and then replace it in the appli-
ance.
Advertisement
Table of Contents
