Table of Contents
Advertisement
Problem
The compressor comes
on less and less often
and for shorter periods
of time. The temperat-
ure in the refrigeration
appliance rises.
Ice or condensation has
built up inside the appli-
ance.
The door seal is dam-
aged or needs to be re-
placed.
Frost has accumulated
on the front panel of the
NoFrost module.
Cause and remedy
Not a fault. The temperature setting is too high.
Correct the temperature setting.
Check the temperature again after 24 hours.
The frozen goods begin to defrost.
The room temperature is too low for this refrigeration
appliance.
If the room temperature is too low, the compressor
will run less frequently. This may cause the freezer
section to become too warm.
See the information under "Installation – Location".
Increase the temperature of the room.
The door seal has come out of its groove.
Check that the door seal is correctly positioned in
the groove.
The door seal is damaged.
Check whether the door seal is damaged.
No tools are required to change the door seal.
Change the door seal. A replacement is available
from Miele or from specialist retailers.
Not a fault. Condensation has settled on the panel
and frozen.
Possible reasons for this include:
– The appliance door has been opened too often or
has been left open.
– A large amount of food being frozen at once.
– The humidity in the room has increased.
Keep the appliance door closed as much as pos-
sible. The NoFrost system will automatically de-
frost the layer of ice over the next few days.
Problem solving guide
57
Advertisement
Table of Contents
