Table of Contents
Advertisement
DOK-GEAR**-GTE********-PR06-EN-P
Rexroth GTE Planetary Gearboxes
11
Commissioning, Operation and Maintenance
11.1
Start-Up
11.1.1
General Information
11.1.2
Preparation
11.1.3
Bulk Head Connector
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
The following commission notes refer to the GTE planetary gearboxes as part
of a drive-system with motor, drive and control unit.
1. Keep the documentation of all products you are using ready.
2. Log all measures taken in the commissioning log.
3. Check the products for damage.
4. Check all mechanical and electrical connections.
5. Activate the safety and monitoring equipment of the system.
NOTICE
●
Do not carry out commissioning if connections, operating states or product
data are unclear or faulty!
●
Do not carry out commissioning if the safety and monitoring equipment of
the system is damaged or not in operation.
●
Damaged products must not be put into operation.
●
Contact Bosch Rexroth for missing information or support during com‐
missioning!
When all requirements are met, proceed as follows:
1. Commission the motors, controllers and power supplies according to the
corresponding descriptions. Note the respective product documentation.
2. Before releasing the setpoint, check whether the set relationship of the
maximum motor speed and the preset setpoint corresponds to the spec‐
ifications for the machine.
3. At a low turning speed, check whether the rotation direction of the gearbox
and the polarity setpoint correspond to the specifications for the machine.
4. At a low turning speed, check whether the positioning commands of the
control systems are executed correctly.
5. Log all measures taken in the commissioning report.
When all steps have been executed correctly, commissioning of the gearbox is
complete.
Commissioning of motors and controllers may require additional steps.
The inspection of the functioning and performance of the systems is not part of
the commissioning of the gearbox; instead, it is carried out within the framework
of the commissioning of the machine as a whole. Observe the instructions and
regulations given by the machine manufacturer.
Bosch Rexroth AG
Commissioning, Operation and Maintenance
Damage to property due to errors in the con‐
trols of motors and moving elements! Unclear
operating states and product data!
69/85
Advertisement
Table of Contents
