Advertisement
1. Fill the tank with kerosene or other approved
fuel until needle on fuel gauge points to "F".
2. Replace fuel cap and tighten firmly.
Connect the heater to a three prong
(grounded) power source. You must use a
three prong (grounded) extension cord that
is at least 6 feet long and is a minimum of 14
AWG rating.
Model 45-KFA:
1.
2. Move power switch to "On" position. The
power indicator light will illuminate and the
heater will ignite. (See Figure 9)
TIP: If the heater does not ignite; move
switch to "Off" position, check steps 1-3
above and then move switch to "On" position.
- To stop the heater, move the power switch to the
"Off" position and unplug the power cord.
- To restart the heater; wait 10 seconds and follow
ignition steps.
Figure 9
© 2015, Pinnacle Products International, Inc.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR
WHILE CONNECTED TO A POWER SOURCE
Power Switch
Models 75T-KFA / 135T-KFA / 190T-KFA / 215T-KFA:
1.
above
2. Turn thermostat control knob to desired
temperature setting. The thermostat set range
is from 40 ºF to 110 ºF.
Move power switch to "On" position. The
power indicator light and room temperature
display will illuminate and heater will ignite.
(See Figure 10)
TIP: If the heater does not ignite, the
thermostat may be set too low. Turn
the control knob to a higher setting until the
heater ignites. If the heater does not ignite;
move switch to "Off" position, check steps 1-3
above and then move switch to "On" position.
The room temperature display will indicate the
- When the temperature is less than 0 ºF the
display says "LO".
- When the temperature is more that 99 ºF the
display says "HI".
- Between 0 °F and 99 °F the display shows
actual temperature.
- To stop the heater, move the power switch to the
"Off" position and unplug the power cord.
- To restart the heater; wait 10 seconds and follow
ignition steps.
Thermostat Knob
Figure 10
Kerosene Forced Air Heater User's Manual
8
Temperature Display
Power Switch
Advertisement
