MG MGB TOURER GHN5 Handbook page 51

Spring clip type (7). Withdraw the three-pin connector, disengage the spring clip
from the reflector lugs, and withdraw the bulb. Fit the new bulb into the reflector,
ensuring that the pip on the bulb flange engages the slot in the reflector. Refit
the spring clip ensuring that the coils in the clip are resting on the base of the
bulb and that the legs of the clip are fully engaged under the reflector lugs. Fit
the three-pin connector.
Headlamp pilot lamp (8). Withdraw the holder from the reflector, press and turn
the bulb anti-clockwise and withdraw it from the holder. Engage the pins of the
new bulb in the grooves of the holder, press and turn the bulb clockwise. Press
the holder into its hole in the reflector.
Refitting. Locate the three lugs on the rear outer edge of the light unit in the
slots formed in the lamp body, and refit the inner rim and its retaining screws.
Position the outer rim on the retaining lugs at the top of the lamp, and press the
rim downwards and inwards.
Beam setting
Two adjusting screws are provided on each headlamp for setting the main beams.
Fig.
5 The screw
(9) is for adjusting the beam in the vertical plane, and the screw (10)
is for horizontal adjustment. The beams must be set in accordance with local
regulations; resetting and checking should be entrusted to 9our Distributor or
Dealer, who will have special equipment available for this purpose.
L A M PS
,
Side and
To gain access to the sidelight (1) and direction indicator (2) bulbs, unscrew the
direction
two retaining screws (3) and withdraw the rim and lens.
indicator
Fig. 6
Courtesy To replace a defective bulb, remove the two screws securing the lamp lens.
Fig.
7 Withdraw the festoon-type bulb f j o ~ the retaining clips.
Fig. 6
Fig. 7