MG MGB TOURER GHN5 Handbook page 24

Body Fittings
Check that the sealing rubbers are correctly positioned, then ~ 1 0 \ \ 1 y and evenly
tighten the side fixing bolts until the hard top seals evenly to the body. AVOID
OVERTIGHTENING. Measure the gap between the hard top and body side
fixing brackets (arrowed, Fig. 20). Remove the bolts and fit washers between the
brackets to the thickness of the gap. Refit and tighten the bolts.
Wind up both windows and check that a gap of approximately
&
in. ( 8 mm.)
exists between the rear edge of the window and the hard top quarter channel.
Adjust if necessary by loosening the side fixing bolts and repositioning the
hard top.
Ensure that there is an adequate seal between the window and hard top rubber
and that the doors. when opened with the windows up, d o not foul the opening
surround.
Removing. Unlock and release the windscreen toggle fasteners. Rernovc the side
fixing bolts. Raise the front of the hard top to disengage the toggle fastener
tongues from the windscreen sockets, move the hard top to the rear to disengage
the anchor plates, then lift it clear of the car.
Reniove the side fixing brackets from the hood support sockets.
Assemble the fittings loosely to thc hard top to prevent loss.
Fig. 20
Fig.
21
22