How To Set The Tilt - Nexus 21 Transcend Pro Installation Instructions Manual

The has +/- 1 degree of Tilt in the Top Position, and +1/-2 Degrees in the Bottom and Out Positions. Below are
the steps on how to set the Tilt for each position of the mount.
Top Tilt Adjustment
Step 1: Fasten the Lock Nuts to each of the Screws
completely. Fasten the Lock Nuts to each of the Screws
completely.
Step 2: Fasten each Screw into the Pem Nuts located
on the left and right side of the Screen Back Plate.
Step 1: Tighten the Bolt shown in the figure below to adjust the bottom tilt +1/-2 degrees.

How to Set the Tilt

Step 3: To increase the Tilt, loosen the Lock Nut on the
Screw and loosen the Screw from the Screen Back Plate.
Note: There is only +/- 1 degree of Tilt in this position.
Bottom Tilt Adjustment
18
Pem Nut Location