Handpiece Setup - Pace TP-65 Operation & Maintenance Instructions Manual

HANDPIECE SETUP

Use the following procedures to set up your handpiece.
Power Receptacle Connection
Connect the handpiece power
cable plug to one of the power
receptacles on your PACE power
source. PACE recommends that
air handpieces utilize the power
receptacles closest to the AUTO
SNAP-VAC (or SNAP-VAC) and
Controllable PRESSURE Ports
to minimize cord tangles. Refer
to the Operation & Maintenance
Manual included with your power
source for details.
Air Hose Connection
There are two methods of attaching the air hose from the PACE power source
to the TP-65. Select the method which best suits your needs. The Quick
Connect Method is best suited for SensaTemp handpiece configurations where
multiple air handpieces may be in use. The Traditional Method is best suited
for single air handpiece configurations.
Regardless of connection method, ensure that only one air hose is
connected to the power source AUTO SNAP-VAC (or SNAP-VAC) or
Controllable PRESSURE Port at one time. Attachment to both ports
simultaneously will cause a deterioration of performance.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
CAUTION