Bestway Lay-Z-Spa 54138 Owner's Manual page 17

1.
5.
NOTE: Dry the SPA pool
8.
(only for Hydro-Jet Pro )
C
Cleaning the spa
NOTE: DO NOT use hard brushes or abrasive cleaners.
Spa Repair
For Spa inflatable cover
If the spa is torn or punctured, use the provided
heavy-duty repair patch.
1. Clean area to be repaired.
2. Carefully peel patch.
3. Press patch over area to be repaired.
4. Wait 30 minutes before inflation.
S-S-003587/21x28.5cm/54138NN 54144NN 欧规SPA说明书/JS-YF-2015-B-04514/英
2.
6.
NOTE: Lift up the SPA when there is
only a few water, damages to the
handles are not cover under warranty.
9.
Detergent residues and dissolved solids from bathing suits and chemicals may build up on the spa walls. Use soap
and water to clean the walls and rinse thoroughly.
3.
7.
NOTE: Dry the SPA pump
10.
(only for Hydro-Jet Pro )
For Spa Liner
If the spa is torn or punctured, use the provided PVC repair patch and glue
(not included) following these steps:
1. Clean and dry the area to be repaired.
2. Cut the provided PVC patch to appropriate size.
3. Use glue (not included) to coat the one side of the newly cut patch.
Make sure the glue is evenly distributed.
4. Wait for 30 seconds and then place the cut patch with glue over the
damaged area.
5. Smooth out any bubbles of air that may be trapped underneath, and
press firmly for two minutes.
6. Wait 30 minutes before inflation.
7. The product is once again ready for use. Repeat this process should
further leaks occur.
17
4.
C
A
C
A
S-S-003587