Installation; Location - Miele KWT 2671 ViS Operating And Installation Instructions

Installation

Location

This appliance should be installed in a
dry, well-ventilated room.
When deciding where to install your
wine conditioning unit, please bear in
mind that it will use more energy if in-
stalled near to a heater, a cooker or an-
other appliance that gives off heat. Dir-
ect sunlight should also be avoided.
The higher the room temperature, the
longer the compressor runs and the
higher the energy consumption of the
wine conditioning unit is.
When installing the wine conditioning
unit, please note the following:
– The socket must be easily accessible
in an emergency, not concealed be-
hind the appliance.
– The plug and power cable must not
touch the rear of the wine condition-
ing unit as they could be damaged by
vibrations from the appliance.
– Do not plug in other appliances be-
hind this wine conditioning unit.
14
If installation near a heat source is un-
avoidable, observe the following min-
imum distances between the appliance
and the heat source:
– At least 3 cm
to electric or gas stoves
– At least 30 cm
to oil or coal-based stoves
If it is not possible to observe these
minimum distances, an isolation plate
must be installed between the wine
conditioning unit and the heat source.