Switching Off The Demo Mode - Miele KWT 2671 ViS Operating And Installation Instructions

Selecting additional settings
Checking the WiFi connection status
 In Settings mode , use the 
and  sensor controls to se-
lect Miele@home
confirm your selection.
 Use the  and  sensor controls to
select
Connection status
to confirm your selection.
Information about the WiFi connection
status will then appear on the display:
–  connected: there is a strong con-
nection
–  connected: there is an average
connection
–  connected: there is a weak con-
nection
– : disconnected
Setting up Miele@home again
If you have changed your WiFi network,
you can set up Miele@home again for
your wine conditioning unit.
 In Settings mode , use the 
and  sensor controls to se-
lect Miele@home
confirm your selection.
 Use the  and  sensor controls to
select
Set up again
confirm your selection.
Reset configuration?
display.
 Use the  and  sensor controls to
select Yes or No
confirm your selection.
68
and select OK to
and select OK
and select OK to
and select OK to
will appear on the
and select OK to
Switching off the Demo
mode 
Demo mode allows the wine condi-
tioning unit to be presented in the
showroom without the cooling sys-
tem being switched on. This setting
is not needed for domestic use.
If Demo mode has been switched on
as a default setting,  will show on the
display.
 In Settings mode , use the 
and  sensor controls to select
mode and select OK to confirm your
selection.
Press OK for 4 seconds to deactivate
appear on the display.
 Follow the instructions on the display.
The countdown Demo mode will deactiv-
will appear on the display.
ate in seconds
Demo mode deactivated. Appliance cooling
will appear on the display.
switched on
 Confirm the message with OK.
The main screen will appear on the dis-
play again.
Demo
will