Inventory - Grizzly H2935 Owner's Manual

Inventory

After all the parts have been removed from the
box and inside of the sanding table, you should
have the following items:
Box 1: (Figure 3 & 4)
A. downdraft sanding table Cabinet ............. 1
B. hanger ....................................................... 1
c. Center panel ............................................... 1
D. Filter 16" x 20" x 2" (h2935) ....................... 1
Filter 16" x 25" x 2" (h2936, not shown) ... 1
E. Filter 16" x 20" x 1 (h2935) ........................ 1
Filter 16" x 25" x 1" (h2936, not shown) ... 1
F. downdraft plates (h2935) .......................... 4
downdraft plates (h2936, not shown) ...... 5
G. right panel ................................................. 1
H. left panel ................................................... 1
I.
hardware (not shown)
— Foot pad screws (Cabinet Base) ............ 4
— hex nuts ⁄ "-16 (Cabinet Base) .............. 4
3
8
—pins (panels) ........................................... 7
—handle (outlet plate) .............................. 1
—hex nut ⁄ "-18 (power Cord hanger) .... 1
5
16
—phillips head screws
Figure 3. Model h2935 out of box.
-14-
Qty
⁄ "-20 x ⁄ " ........... 2
1 5
4 8
A
C
B
h
Figure 4. Model h2935 inventory.
in the event that any nonproprietary parts are
missing (e.g. a nut or a washer), we would be
glad to replace them, or for the sake of expedi-
ency, replacements can be obtained at your local
hardware store.
NOTICE
Some hardware/fasteners on the inventory
list may arrive pre-installed on the machine.
check these locations before assuming that
any items from the inventory list are miss-
ing.
SuFFOcATION HAzARD!
Immediately discard all plas-
tic bags and packing materi-
als to eliminate choking/suf-
focation hazards for children
and animals.
Model h2935/h2936 (Mfg. since 2/12)
d
E
F
g