molex MOD-Clip Installation Instructions

MOD-Clip™ UTP Four Pair Termination Tool

1. SCOPE

This document covers the instructions for the proper use and maintenance of the
Four Pair Termination Tool. The tool is designed to terminate 23-24 AWG solid
conductors used to terminate the MOD-Clip™ jacks.
Order
SAP No.
No.
31.0010 182520001
31.0012 182520003

2. COMPONENTS

1) Tool frame
2) Cable termination head
3) Termination head pivot
4) Modclip pusher
5) Handle latch
MPN NO. : 215-435
© 2013 Molex
THIS INFORMATION IS CORRECT AS AT THE TIME OF PUBLICATION, SPECIFICATION ARE SUBJECT TO CHANGE

INSTALLATION INSTRUCTIONS

Fig-1
Description
MODCLIP TERMINATION TOOL FRAME
UTP Termination Head
Fig-2
SAP NO.:187000427

3. TOOL SET UP

Ensure that the correct lacing head is assembled in the tool frame.
1. For MODCLIP™ jacks the UTP termination head should be used (Refer Fig.3)
IMPORTANT Note: For termination of the C6A MOD-Clip jack use Termination
Tool Frame part no 31.0011. The MOD-Clip Termination frame is not
designed to terminate the MOD-Clip C6A shielded jack

4. FIT THE TERMINATION HEAD.

1. Position the UTP Termination head as shown in fig. 4.
2. Install the two (2) Termination head screws. Avoid damaging the screw by
over-tightening. Not to exceed torque of 1.25N-m (11 inch-pounds)
Fig-4
OPERATION:
CAUTION: Terminate only Molex UTP MOD-Clip jacks with this tool. Do not
terminate other products or hardened objects as damage can occur to the tool.
While squeezing the handles together, pivot the handle latch away from the pin,
and tool handles will spring open.
AS-18700-121
http://www.molexpn.com/
BEFORE INSTALLING OR ADJUSTING THIS PRODUCT,
PLEASE READ THESE INSTRUCTIONS CAREFULLY.
PLEASE KEEP THIS GUIDE FOR FUTURE REFERENCE
Fig-3
Fig-4.1
REV-A, 2014/12/10
MTS2015-0015
SHEET No. 1 of 4