Rohde & Schwarz R&S FPH User Manual page 262

R&S ® Spectrum Rider FPH
1. Measurement (or receive) frequency
2. Power level measured at the receive frequency
3. Horizontal bargraph that graphically represents the currently measured power
level.
In the default state, the R&S Spectrum Rider performs the measurement on a single
receive frequency. If it instead shows the result display for a frequency scan, you can
access the single frequency result display manually.
1. Press the [MEAS] key.
2. Select the "Fixed Freq" softkey.
The R&S Spectrum Rider shows the result display for single frequency measurements.
1 = Operating mode
2 = Measurement result view
3 = Parameter view
4 = Corresponding power level of the receiver frequency
5 = Maximum hold power level of the receiver frequency
6 = Refresh button to refresh maximum hold power level of the receiver frequency
7 = Bargraph
8 = Maximum hold power level indicator
9 = Upper limit threshold indicator
10 = Lower limit threshold indicator
11 = Configuration overview
12 = Receiver softkey menu
User Manual 1321.1011.02 ─ 06.00
Receiver Mode
Selecting the Measurement Mode
257