Mitsubishi Electric City Multi PLFY-P VCM-E3 Series Installation Manual page 8

1
2
3
Model
PLFY-P15VCM-E3
PLFY-P25VCM-E3
PLFY-P32VCM-E3
8
.) (1s DIGIT)
(BRANCH No
Power supply
Max.: 264V
indoor unit TB5 is a shielding wire connection. For specifications about the con-
necting cables, refer to the outdoor unit installation manual.
ler.
1
MA Remote controller
2-wire)
2
M-NET Remote controller
(Nonpolarized 2-wire)
3
Wireless remote controller (When installing wireless signal receiver)
troller board.
controller, connect TB15 each with the same number.
controller. (In the default setting of indoor unit and wireless remote controller, Pair
A
Terminal block for indoor transmission cable
B
Terminal block for outdoor transmission cable (M1(A), M2(B),
C
Remote controller
D
Wireless signal receiver
E
Wireless remote controller
(Be sure to operate with the main power turned OFF.)
1
How to set addresses
(for 1 to 9) with "3".
2
How to set branch numbers SW14 (Series R2 only)
Match the indoor unit's refrigerant pipe with the BC controller's end connection
number.
can be used to set unit addresses and branch numbers at will.
referring to the Data Book.
in a remote controller
If you want to sense room temperature with the built-in sensor in a remote controller,
necessary also makes it possible to adjust the air flow at a time when the heating
thermometer is OFF.
IFM: Indoor Fan Motor
MCA (A)
2 junction cable.
(S))
Output: Fan motor rated output
IFM
Output (kW) FLA (A)
-
2