Transaxle Bypass Controls - Alamo Bush Hog HDE-2 Series Operator's Manual

2. The Backrest Angle Adjustment Knob.
3. Arm Rest Height adjustment (raise arm rest to access
adjustment knobs).
4. Seat Slide allows 6" of fore and aft adjustment.
The seat is shaped to increase air flow so that you stay
more comfortable on hot days
Transaxle Bypass Control
Transaxle Bypass Linkages
The Transaxle Bypass Linkages must be pulled out
when pushing or pulling the Zero Turn Mower without en-
gine power. The linkages are located at the rear of the
Zero Turn Mower under the engine plate. The linkages
must be pulled out and locked in order to relieve hy-
draulic pressure so the Zero Turn Mower can be moved.
Refer to Moving the Zero Turn by Hand in the Opera-
tion Section.
NOTE: The Tansaxle Bypass Linkages must be disen-
gaged in order for the Zero Turn Mower to move forward
or backward under its engine power.
!
CAUTION
The Bypass Linkage is located close
to the muffler. To prevent burn injury,
turn the engine off and allow the engine and muffler to
cool down before handling the Bypass Linkage.
HDE-2 ZT 04/18
© 2018 Alamo Group Inc.
CONTROLS
Controls Section 3-7