Assembly
1
Attaching The Wheels To The Tank
Assembly
NOTE: If permanently anchoring the heater to the ground
or patio, skip to step 2.
□ Line up holes in the wheels (F) with the corresponding
holes in the base of the tank assembly (E) and insert two
M8x16 screws (AA) through the holes. Finger tighten the
bolts.
□ Make sure the wheels (F) are parallel to the base of the
tank assembly (E) and then fully tighten the bolts using the
wrench (JJ).
2
Attaching The Cylinder Ring
□ Attach the cylinder ring (G) to the base of the tank
assembly (E) using three M8x12 screws (GG) and three M8
nuts (HH) which are preassembled with the
□ Adjust the M8x45 screw (II) preassembled in the cylinder ring
(G) to secure the LPG cylinder.
cylinder ring (G).
5
Please contact customercare@jrhome.com or 1-800-561-5550 for further assistance.
E
F
PARAMOUNTATHOME.COM