Brush Controller; Filter Level Indicator; Swivel Neck Latch; Changing The Paper Bag - Windsor Versamatic Plus VSP 18 Manual

Preparation

Brush controller

The electronic brush controller monitors the
operation of the brush.
Green light: Brush correctly set and running.
Green light and red light: Adjust the brush
setting by turning the Pile adjustment knob (23)
to a lower number.
If the lights still show at position number one
the brush strip is worn out and must be
replaced.
Red light: The brush has become blocked and
is not turning. Switch off. Unplug from the outlet
and clear the blockage.

Filter level indicator

If warning light (3) comes on check:
a) Is the dust bag full?
b) Is there a blockage in the hose or power
head ?

Swivel neck latch

To release the machine from the upright
position depress the foot pedal (11).

Changing the paper bag

If red light (3) shows, change paper filter bag.
To do this first pull cover release latch (5) -
forward and lift the cover from the dust bag
housing. Slide the dust bag sealing plate (28)
from the holder (29). Slide the sealing plate (28)
of a new bag into the holder and push firmly in.
Insert cover into dust bag housing. Push it
forward then lock it in place by pushing down
the cover release latch.

Changing the motor filter

Motor filter (30, Art. no. 1825) needs to be
replaced latest after the use of 20 filter bags.
Lift the front of the filter slightly and slide it out
of its slots. Instead of the motor filter a
' Hospital-Grade' -microfilter is available
(Art. no. 1875).

Changing the exhaust filter

Change the exhaust filter (31, Art. no. 1878)
always with the motor filter (30). Press the
button and slide the exhaust cover (6) to the
side.
Never use the machine without correctly
attached filters.