Maintenance; Brush Cleaning And Maintenance; Motor Replacement & Belt Tensioning - Windsor IMIE17 10066550 Operating Instructions Manual

Maintenance

Brush Cleaning And Maintenance

After each session of carpet cleaning, the brushes and
the brush housing should be cleaned. Before cleaning
or changing the brushes, always unplug the machine
from the power supply.
Brushes are removed without tools. After handle is in
locked position, tilt the machine back and rest on
handle. To release brush from spring clip pull spring clip
away from brush end cap. Lift brush out of machine.
The brushes may be soaked in warm or hot water using
mild detergent, and then rinsed with warm water.
NOTE: Brushes with crushed bristles can often be
restored to original condition by soaking in hot water.
Keep brushes clean and free from debris. Rotate
brushes after every use as this will increase the life
span of the brushes and ensure even wear.
Before reinstalling brushes, clean out machine brush
housing and hopper by wiping with a clean damp cloth.
Motor Replacement & Belt Tensioning
1. Disconnect machine power supply.
2. Detach quick disconnect hose from top of solution
tank. (Deluxe Only)
3. Remove elastic straps and solution tank. (Deluxe
Only)
4. Remove two dome screws and dome assembly.
CIRCUIT BREAKER
& BOOT
WIRING GROMMET
5. Remove the circuit breaker boot and push the
circuit breaker clear of cover.
14
6. Mark left and right on the lift cams.
7. Remove the two cam bolts. This will also free the
NOTE: There are four plastic bushings that the
handle pivots on, leave them on the motor clamps.
LIFTING CAM
RIGHT
8. Remove the handle assembly.
9. Unscrew the wiring grommet from the main cover,
10. Remove the the front and back screws and move
NOTE: The handle assembly and cover are still
attached to the frame by wiring. Be careful not to
pinch wiring when reassembling.
11. Remove the (2) plastic finger guards.
12. Remove the motor clamps and lift brackets.
DOME
COVER
86269870 CARPET MAINTAINER
lift cams.
and set retaining bracket and screw aside.
the main cover to the side.
MOTOR CLAMP
LIFT BRACKET
MOTOR
PLASTIC FINGER
GUARD (2)
LIFTING CAM
LEFT