To Set Ixge Parameters In A Linux Environment - Sun Microsystems Ethernet PCI-X Adapter Installation And User Manual

To Set ixge Parameters in a Linux Environment

1. Remove the Sun 10-Gigabit Ethernet PCI-X device driver, if it is already loaded.
# rmmod ixge
2. Load the Sun 10-Gigabit Ethernet PCI-X device driver:
# modprobe ixge
or you can use the insmod command:
# insmod ixge
where VAL1 applies to the first ixge interface and VAL2 to the next interface and so
on.
Appendix D
option=VAL1, V AL2, . . .
option=VAL1, VAL2, . . .
Installing the Sun 10-Gigabit Ethernet Device Driver on Linux Platforms 57