Rebooting The System - Sun Microsystems Ethernet PCI-X Adapter Installation And User Manual

4. View the .properties file for a list of device properties.
The .properties command displays the specific information about the installed
adapter. If you are using the Sun 10-Gigabit Ethernet adapter, your output will be
similar to the following:
ok cd /pci@9,600000/ethernet@1
ok .properties
assigned-addresses
reg
compatible
name
66mhz-capable
devsel-speed
class-code
interrupts
latency-timer
cache-line-size
max-latency
min-grant
subsystem-id
subsystem-vendor-id
revision-id
device-id
vendor-id
ok
5. Type the following when you finish looking at the .properties values:
ok device-end

Rebooting the System

After verifying the adapter installation, use the boot -r command to perform a
reconfiguration boot on your system.
ok boot -r
10 Sun 10-Gigabit Ethernet PCI-X Adapter Installation and User's Guide • December 2005
83000810 00000000 00100000 00000000 00008000
81000820 00000000 00000300 00000000 00000020
00000800 00000000 00000000 00000000 00000000
03000810 00000000 00000000 00000000 00008000
01000820 00000000 00000000 00000000 00000020
70 63 69 38 30 38 36 2c 31 30 34 38 2e 38 30 38
ethernet
00000001
00020000
00000001
00000040
00000010
00000000
000000ff
00007036
0000108e
00000002
00001048
00008086