Using The Instrument; Maintenance - OHAUS Valor 4000W Series User Manual

TM
Valor 4000 Series
3.2 Display
1
1
1
2
1
3
1
4
1
5
1
6
1
7
Item Description
1 NET symbol
2 Center of Zero symbol
3 Negative symbol
4 Stable weight symbol
5 Preset Tare symbol*
6 Pointer symbols
7 IR Sensor symbol
8 Accumulation symbol
Note: * Not Used
IR Sensor
The colored LED indicators on the right side of the control panels are used in Checkweigh mode (section 3.6) and will light up
according to the following rules:
(Red) Loads > Upper limit
(Green) Loads ≥ Lower limit and ≤ Upper limit
(Yellow) Loads < Lower limit

3.3 Using the Instrument

Weiging application:
1.Press and hold Mode until [wJeIGH] (Weigh) is displayed.
2.If required, place an empty container on the pan and press Tare.
3.Add sample to the pan or container. The display shows the weight of the sample.

4. MAINTENANCE

4.1 Cleaning
WARNING: Electric Shock Hazard. Disconnect the equipment from the power supply before cleaning.
Make sure that no liquid enters the interior of the instrument.
Attention: Do not use solvents, harsh chemicals, ammonia or abrasive cleaning agents.
The exterior surfaces of the instrument may be cleaned with a cloth dampened with water and a mild detergent.
1
8 1
9
Item
Rear display.
.
Description
9 Calibration / Menu Mode symbol
10 Dynamic symbol*
11 Battery charge symbol
12 Pound, Ounce, Pound:Ounce symbol
13 Gram, Kilogram symbols
14 Pieces symbol*
15 Percent symbol
15
1
14
1
13
1
12
1
10 11
1 1
LED Indicators
EN-3