Chapter 2 Connecting The 5G Home Router; Setting Up The 5G Home Router; Configuring The 5G Home Router - Verizon 5G Home Router User Manual

Chapter 2
Connecting the 5G Home Router
This section describes how to set up and configure your 5G Home Router.
2.1

Setting up the 5G Home Router

1. Unbox the 5G Home Router, AC adaptor, and Ethernet cable.
2. Plug the AC adaptor into an electrical outlet, then connect the other end to the power jack on
the back of the 5G Home Router.
3. Plug an Ethernet cable into the WAN port on the back of the 5G Home Router, and plug the
other end of the Ethernet cable into an Ethernet port on your CPE.
Optional
If an Ethernet cable is not used, you can connect to the CPE using WPS:
Press the WPS button on the CPE and that of your 5G Home Router. Make sure the CPE is
within range of the 5G Home Router. The circular LED light will illuminate blue for two
seconds to indicate pairing success. You may also use the WPS button in the Web User
Interface to activate WPS by clicking Wi-Fi Settings > WPS, and click on the Primary Wi-Fi
WPS button.
Note: It's recommended that you move the device to be paired into close proximity of the 5G
Home Router (preferably less than a meter away), making it easier to press pairing buttons
within the allotted 2 minutes in the WPS procedure. After pairing is successful, you can then
move the 5G Home Router to the location of your choice and check the LED for Wi-Fi signal
strength at the chosen location.
2.2

Configuring the 5G Home Router

Connect a computer to the 5G Home Router and open a web browser. Type
the address bar, and press Enter (on the computer's keyboard). A login screen will then appear.
5
http://my.router in