Make sure that the module is firmly mounted onto the
standard rail. Try to remove the module from the standard
rail with a little pressure. If the module remains firmly
connected to the rail with this test, the mounting is correct.
If multiple modules are mounted:
Slide the individual modules together in the direction of the
arrow until the lateral connector between the modules
audibly snaps into place.
Install an end terminal on the leftmost module and the
rightmost module.
After mounting
4.1.2
After mounting the modules, the following steps are required:
Electrically connect the modules.
Configure the modules.
Check installation before initial commissioning.
4.2
Steps for removing the extension modules
Disconnect the MSI 400 system from the power supply.
Remove the plug-in block terminals with the wiring and the
end terminals.
Leuze electronic GmbH + Co. KG
info@leuze.de • www.leuze.com
Slide the modules apart separately in the direction of the
arrow until the lateral connector is disconnected.
Unlock the module.
To do so, pull the module's latching foot outwards with a
screwdriver.
Swivel the module away from the standard rail.
In der Braike 1 D-73277 Owen
Tel. +49 (0) 7021 573-0
We reserve the right to make changes
02/2018 – 50134618-01 – 7/10