Cavity Wall Installation; Replace The Front Cover - ABB M2231 Series Product Manual

7.3.9

Cavity wall installation

Fig. 13: Cavity wall installation
[1] Attach a pair of supporting brackets to the back cover of the indoor station. Place 4 screws
through the back cover and attach with 4 claw brackets.
[2] Rotate 4 claw brackets to attach to the supporting brackets and pull the rubber bands
around the corner of the claw brackets to fix the claws.
[3] Put the back cover into the cavity wall
[4] Tighten the screws
[5] Latch the upper part of the indoor station onto the bottom part. Place the upper side of the
indoor station on the lock-in lugs and then press the bottom side onto the bottom part of the
device until it is caught by the clamp.
7.3.10

Replace the front cover

Fig. 14: Replace the front cover
The installation of the indoor station is now complete.
Product manual 2TMD041600D0107
Mounting/Installation
│16