Fault Codes & Diagnostics - Hotpoint Ultima FDW85 Service Information

If an error is detected in programme, the programme will be terminated and one of the following errors
will be displayed on the LCD.
Fault Fault
Code
AL 01 Overflow (water in base
pan).
AL 02 Solenoid valve broken.
AL 03 Time out draining
AL 04 Thermistor circuit
AL 05 Filters blocked
AL 06 Time out filling
AL 08 Time out heating
AL 09 Software recognition
error
AL 10 Heating circuit
AL 99 Communication
problem
H20 Time out filling
In the event of any of the above codes being displayed, after the fault has been rectified it will be
necessary to reset the machine. This is achieved by pressing and holding the Start/Reset button.
After a few seconds the fault code will be replaced with dashes on the LCD display.
FAULT CODES & DIAGNOSTICS
Possible Cause(s)
Leak from water line.
Inlet valve, letting by, heater Earth fault, open circuit
heater
Pump connections, blockage, module
Thermistor c/w timer
Mesh plate, filter or microfilter, pressure sensor, pressure
switch, circulation pump
Inlet valve, connections, timer, water turbine
NTC detached from casing
Timer not programmed, wrong keypad
Heating element, connections, module, relay.
Bit100 Timer Card, delay or connecting cable
Customers tap not turned on
20