Table of Contents
Advertisement
1.9 The docking of unit sections
The illustrations in Section 1.10 show a SILVER C RX unit with Fan Arrange-
ment 2. The principle is however the same for the other units.
1.9.1 Fan/filter/coil heat exchanger sections (Coil
heat exchanger sections SILVER C CX only)
1.9.2 Fastening, front/middle section
Locate the fan/filter sections by the heatexchanger section
according to the delivery configuration (see Section 1.8).
Fix the fan/filter sections at thefront side of the air handling
unit to the heat exchanger section with the bolts supplied,
screwing them into the prefitted rivet nuts (a total of 2x4 pcs.).
We reserve the right to alter specifications.
GB.SILVERF120.181005
Place the fan, filter and possible coil heat exchanger
sections on top of one another, according to the deliv-
ery configuration (see Section 1.8). Secure the upper
section to the lower section with the bolts supplied,
screwing them into the pre-fitted rivet nuts (a total of
4 pcs.).
Secure the fan/filter sections to the
heat exchanger section inside the
air handling unit's middle section
using the supplied screws in the pre-
fitted rivet nuts (total 2x8 pcs.). The
anchoring points inside the unit are
shown in the illustration.
In order to access the anchor points
in the fan section, you must unfasten
the flexible connections and the fan
assemblies and move them outward
toward the inspection door. You can
then tighten the screws from the
opening of the duct connection.
NOTE! You do not need to remove
the fan assemblies completely!
www.swegon.com
19
Advertisement
Table of Contents
