Lighting Instructions - Napoleon BILEX605 Manual

Lighting Instructions

!
WARNING!
WARNING!
valve.
turn light the selected burner. If the pilot
!
WARNING!
turned off prior to turning the cylinder on, only small flames and low heat will be achievable.
WARNING!
N415-0272 DEC 20.18
N415-0272 DEC 20.18.indd 7
Lights
Left
Burner
Open lid.
Ensure all burner controls are in the off position. Turn on the gas supply
Main Burner
Lighting
1. Open grill lid.
2. Push and turn any main burner knob
slowly to the 'hi' position. This action
will ignite the pilot flame which will in
lights, continue to push down on the
control knob until the burner lights and
then release.
3. If the pilot does not ignite, then
immediately turn the control knob back
to the 'off position and repeat step 2
several times.
4. If the pilot and burner will not ignite
within 5 seconds, turn the control knob
to the 'off' position and wait 5 minutes
for any excess gas to dissipate. Either
repeat steps 2 and 3 or light with a
match.
5. If lighting the unit with a match, clip
the match into the supplied lighting
rod. Hold the lit match down through
the grill and sear plate while turning the
corresponding burner valve to high.
The propane cylinder is equipped with an excess flow device. Unless all burners are
Do not use the rear burner (rotisserie burner) with the main burners operating.
Rear Right Centre
Left Centre
Burner Burner
Burner
Rear Burner Lighting
(Rotisserie Burner)
(if equipped)
1. Open grill lid.
2. Remove the warming rack.
3. Push and turn the rotisserie burner
control knob slowly to the 'hi' position.
This action will ignite the pilot flame
which will in turn light the burner. If
the pilot lights, continue to push down
on the burner control knob until the
burner lights then release.
4. If the burner does not ignite, then
immediately turn the control knob back
to the 'off' position and repeat step 3
several times.
5. If the burner will not ignite within 5
seconds, turn the control knob to the
'off' position and wait 5 minutes for any
excess gas to dissipate. Either repeat
steps 3 and 4 or light with a match.
Infra Red
Burner
Off Position
Side Burner Lighting
(If equipped)
1. Open side burner cover.
2. Push and turn side burner
control to high position.
3. Press and hold igniter button
until burner lights, or light by
match.
4. If the burner will not ignite
within 5 seconds, turn the control
knob to the 'off' position and wait
5 minutes for any excess gas to
dissipate. Either repeat steps 2
and 3 or light with a match.
www.napoleongrills.com
7
EN
1/2/2019 4:03:37 PM