Table of Contents
Advertisement
Chapter 2. Preparing to Install the Adapter
This chapter covers the things you need to do before you install your 10/100 Mbps
Ethernet PCI Adapter II. Preparing to install the adapter involves the following tasks:
v Verifying your hardware requirements
v Verifying your software requirements
v Making sure your package is complete
v Gathering tools and documentation
Verifying Your Hardware Requirements
The 10/100 Mbps Ethernet PCI Adapter II requires the following hardware:
v A wrap plug for the RJ-45 connector, if you are running the total diagnostics package
v Category 3, 4, or 5 unshielded twisted pair cables for a 10 Mbps network attachment
v Category 5 unshielded twisted pair cables for a 100 Mbps network attachment
Note: The above cable-segment length can be no longer than 100 meters (330 feet).
Verifying Your Software Requirements
The 10/100 Mbps Ethernet PCI Adapter II is supported on several operating systems,
including AIX 4.3.3 or later. Ensure that your operating system supports this adapter
before you install the adapter. Contact your support representative for assistance.
Important: If you are installing your operating system at this time, install the adapter
Checking Your Package
Check that your package contains the following items:
v The 10/100 Mbps Ethernet PCI Adapter II
v A registration card
Contact the place of purchase if an item is missing or damaged.
Important: Be sure to retain your proof of purchase as it might be required to receive
This is the maximum allowable cable length from the adapter to the local
concentrator, including patch cables.
before you install the operating system (see "Chapter 4. Installing the
Adapter" on page 7 for instructions). If you are installing only the device
driver for this adapter, install the device driver before you install the
adapter. (See "Chapter 3. Installing the Device Driver" on page 5 for
instructions.)
warranty service.
3
Advertisement
Table of Contents
