Parameterizing the SITOP UPS1600
6.2 Switching off the UPS by a user program when the power fails
Procedure
1. In the program folder of your project, open the symbol table "Symbols_UPS1600".
2. Match the addresses of the following symbols with the selected I/O address areas of the
3. Save the project and load the parameters into the S7 IO controller.
When the power fails, the user program now switches off the UPS.
40
corresponding UPS1600 parameters:
– UPS_Battery_charge_level
– UPS_Buffer_mode
– UPS_New_alarms_pending
– UPS_Ready_for_buffering
SITOP UPS1600 under STEP 7 V5
Getting Started,