Operation; Attaching The Disc Guard Cover Using The Quick-Release Fastener - Parkside PWS 230 A1 Translation Of The Original Instructions

DANGER! GUIDE THE APPLIANCE
THROUGH THE WORKPIECE IN
REVERSE ROTATION.
► In the opposite direction there is a risk of
kickback. The appliance can be pushed out
of the cut.
■
Always switch the appliance on before ap-
plying it to the workpiece. After completing
the task, lift the appliance from the work piece
and then switch it off .
■ Always hold the appliance fi rmly with two
hands while working. Ensure that your stance
is secure and stable.
■ For an optimum grinding eff ect, move the ap-
pliance evenly at an angle of 15° to 30° (be-
tween grinding disc and workpiece) backwards
and forwards.
■ When working on angled surfaces, do not
exert great force on the workpiece. If the
rotational speed drops signifi cantly, you must
reduce the pressure exerted to allow safe and
eff ective working. If the appliance suddenly
brakes completely or jams, it must be switched
off immediately.
■ Cutting: Work with a moderate feed and do
not tilt the cutting disc.
■ Roughing and cutting discs become very
hot – let them cool down completely before
touching them.
■ Never use the appliance for purposes other
than the ones for which it was designed.
■ Always make sure that the appliance is turned
off before plugging it into the wall socket.
■ In case of danger, remove the plug from the
socket immediately. Ensure that the appliance
and the power socket are easily and quickly
accessible in the event of an emergency.
■ Always remove the plug from the power
socket during work breaks, when adjusting
the appliance and when it is no longer in use.
The appliance must always be kept clean, dry
and free from oil or grease.
■
Remain alert at all times! Always pay attention
to what you are doing and act with common
sense. Never use the appliance when you are
distracted or don't feel well.
PWS 230 A1
Wear protective glasses!
Wear a dust mask!

Operation

Attaching the disc guard cover using
the quick-release fastener
WARNING – RISK OF INJURY!
► Pull the mains plug out of the mains socket
before you carry out any task on the device.
RISK OF INJURY!
► Always use the angle grinder with the blade
guard . The blade guard should be installed
securely. Set it so that the highest possible
degree of safety is achieved, i.e. the smallest
possible part of the grinding disc is exposed
to the operator. The blade guard
signed to protect the operator from fragments
and accidental contact with the grinding tool.
RISK OF INJURY!
► Ensure that the guard
edge is beyond the angle of the auxiliary han-
dle (see Fig. B). Otherwise you could injure
yourself against the grinding or cutting disc.
♦ Open the clamping lever
♦ Insert the disc cover guide
projection in the coded groove
♦ Turn the disc guard cover
position (working position). The closed side of
the disc guard cover
the operator.
♦ Close the clamping lever
the disc guard cover
the clamping force of the connection can be
adjusted by tightening or loosening the adjuster
screw . Ensure that the disc guard cover
sits fi rmly on the spindle collar.
is de-
is attached so that its
.
with the coded
.
into the desired
must always be facing
to fi rmly clamp
in place. If necessary
9
GB