Perlick RS-CDK Installation Instructions Manual page 12

CONNECTING THE REGULATOR TO THE NITROGEN CYLINDER
NITROGEN
12 | perlick.com/residential
PERLICK RESIDENTIAL RS-CDK INSTALLATION INSTRUCTIONS
INSTALLATION
1. Remove the blue plug from the regulator fitting, but do not
remove the carbonic washer.
2. Screw regulator onto gas cylinder valve. Tighten with wrench
until vertically straight. Be sure that the shut-off valve on the
regulator is in the OFF (horizontal) position.
3. Place screw clamp over the end of red line and push onto
regulator tail piece. Tighten clamp with a screwdriver.
4. Turn regulator adjusting screw counterclockwise until it turns
freely.
NITROGEN
5. Turn hand valve counter-clockwise on the nitrogen cylinder
to the fully open position.
6. Turn regulator adjusting screw clockwise until desired
pressure is reached (approximately 12-15 lbs.) Tighten stop
nut on adjusting screw.
7. Open shut-out valve on bottom of regulator.
8. Dilute a small amount of liquid dishwashing soap and rub
the soapy mixture around connections. If bubbles appear,
tighten connection.