Table of Contents
Advertisement
26 GETTING TO KNOW YOUR VEHICLE
NOTE: To avoid unintentional shut downs, the system will
disable the one time push of the remote start button for two
seconds after receiving a valid remote start request.
To Exit Remote Start Mode And Drive The Vehicle
Before the end of 15-minute cycle, push and release the
unlock button on the key fob to unlock the doors, or unlock
the vehicle using Keyless Enter-N-Go — Passive Entry via
the door handles, and disarm the vehicle security alarm (if
equipped). Then, prior to the end of the 15-minute cycle,
push and release the START/STOP button.
NOTE: For vehicles equipped with the Keyless Enter-
N-Go — Passive Entry feature, the message "Remote Start
Active — Push Start Button" will display in the instrument
cluster display until you push the ignition START button.
Remote Start Comfort Systems — If Equipped
When Remote Start is activated, the heated steering wheel
and driver heated seat features will automatically activate
when ambient temperature is less than 40° F (4.4° C). These
features will stay on through the duration of Remote Start
or until the ignition switch is cycled to the RUN position.
Refer to Uconnect Settings in Multimedia for further
information.
Remote Start Windshield Wiper De–Icer And Rear
Defrost Activation — If Equipped
When remote start is active and the outside ambient
temperature is less than 40°F (4.4°C), the Windshield Wiper
De-Icer and the Rear Defrost will be enabled. Exiting
remote start will resume previous operation, except if the
Windshield Wiper De-Icer is active. The Windshield Wiper
De-Icer timer and operation will continue.
Refer to Uconnect Settings in Multimedia for further
information.
General Information
The following regulatory statement applies to all radio
frequency (RF) devices equipped in this vehicle:
This device complies with Part 15 of the FCC Rules and
with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, in-
cluding interference that may cause undesired opera-
tion.
Advertisement
Chapters
Table of Contents
