Table of Contents
Advertisement
CS3U-MB-FG AND CS3U-PB-FG
Clamp length ≥ 80 mm
A = 1000 mm
Maximum Load:
Uplift load ≤ 1650 Pa
Downforce load ≤ 1650 Pa
Two modules share one tube, portrait or landscape installation. Use 4 clamps on the long side of each module.
Mounting rails run parallel to the long side frame. Mounting rails fixed on torque tube (tracker).
6.3
MOUNTING METHODS FOR FRAMED BIFACIAL
MODULE (BOLTING)
· The mounting method has been qualified by Canadian
Solar Inc., as well as certified by VDE and CSA.
Use 4 clamps on the long side.
Mounting rails run parallel to the long side frame.
Mounting rails fixed on torque tube.
Clamp
Tube
Rail
Clamp length ≥ 130 mm
A = 460 ± 20 mm
Maximum Load:
Uplift load ≤ 2400 Pa
Downforce load ≤ 2400 Pa
Clamp
Rail
Tube
Clamp length ≥ 130 mm
A = 1000 mm
Maximum Load:
Uplift load ≤ 2400 Pa
Downforce load ≤ 2400 Pa
A
A
A
· Modules should be bolted to support structures th-
rough the mounting holes in the rear frame flanges
only.
· Each module must be securely fastened at a minimum
of 4 points on two opposite sides.
| 15
Clamp
Rail
A
A
Tube
A
Advertisement
Table of Contents
