The information contained in this manual is subject GENERAL SAFETY to change by Canadian Solar Inc. without prior notice. Canadian Solar Inc. gives no warranty of any · All modules must be installed by licensed electricians kind whatsoever, either explicitly or implicitly, in accordance with the applicable electrical codes with respect to the information contained herein.
(roof, facade, in turn may compromise module reliability and support, etc.) can bear the module system load. void Canadian Solar Inc’s warranty. · Canadian Solar Inc. double glass solar modules www.canadiansolar.com...
OPTIMUM ORIENTATION AND TILT connectors. · To maximize your annual yield, find out the optimum · For CS3U and CS3K series modules, Canadian Solar orientation and tilt for PV modules in your region. Inc. offers optional cable specifications to match The highest yields are achieved when sunlight various system configurations.
· Clamp material should be anodized aluminum alloy or steel of appropriate grade. One buffer rubber material (Recommended material is EPDM) must be added between the clamp and the glass. · Canadian Solar Inc. warranty may be void in cases Rail Bolt Bottom End Clamp...
Page 11
| 11 ANNEX A: MECHANICAL AND ELECTRICAL RATINGS Standard Test Conditions are: irradiance of 1 kW/m within ±10 percent or [0; +5 W] of the indicated valu- air mass (AM) spectrum of 1.5, and cell temperature es for Isc, Voc and Pmax. Specifications are subject of 25°C.
Page 13
| 13 Maximum Operating Operating Open Circuit Short Circuit Max. Series Overall Weight Module Type Power voltage current Voltage Current Fuse Dimension <kg> Pmax <W> Vmp <V> Imp <A> Voc <V> Isc <A> Rating <A> <mm> CS6K-250MS-FG 30.5 37.7 9.03 CS6K-255MS-FG 30.7 8.31...
Page 17
| 17 Table 3: CS6X-P-FG and CS6X-M-FG compatible clamps Mounting Clamp Quantity Certification Supplier Clamp Image Clamp Type & length Load (Pa) Method & Location Body SA-TOK-UA (End clamp) six clamps, NISSEI METALS / SA-KOK-UA (Middle A=300±20mm, Downforce load≤2400 Pa 3-A-1 CO.,LTD.
Page 18
Downforce load≤5400 Pa 3-F-4 VDE / CSA clamp), B=684±20 mm, Uplift load ≤2400 Pa clamp length=130 mm see illustration B The following clamps in table 4 have been approved as compatible with Canadian Solar double glass module CS3K-MS-FG and CS3K-P-FG.
Page 19
Technology A=380±20 mm, VDE / CSA clamp), Uplift load ≤2400 Pa see illustration A (Suzhou) Co.,Ltd. clamp length=200 mm The following clamps in table 5 have been approved as compatible with Canadian Solar double glass module CS3U-MS-FG and CS3U-P-FG. www.canadiansolar.com...