Monitor Programming - Fermax LOFT COMPACT VDS User& Installer's Manual

Loft Compact VDS Loft Compact VDS Loft Compact VDS Loft Compact VDS Loft Compact VDS Loft Compact VDS Loft Compact VDS Loft Compact VDS Loft Compact VDS Loft Compact VDS

MONITOR PROGRAMMING

Option 1: From Panel + Monitor
1
1º. With the monitor connected, press the programming button. A confirmation tone is heard.
2º. Press the house call button. Another confirmation tone is heard.
* The monitor will not work unless it has been programmed.
Option 2: From the Monitor
1. Enter configuration mode: Press the
and a confirmation tone is heard.
2. Set the monitor in programming mode: With the monitor connected, press the programming button
for 1 second.
At this point, the call number currently programmed is indicated by means of high-pitched tones. First,
the Hundreds, then Tens, and finally the Units.
To separate each unit, the LED comes on and a lower tone is heard.
3. Program the call number: Every time the button corresponding to hundreds, tens or units is
pressed, the figure increases by one.
Hundreds: Press the
Tens: Press the
Units: Press the
4. Exit programming: Press the programming button or wait for 30 seconds without pressing any buttons.
When you exit prgramming mode, the number indicated is stored. If it is correct (between 1 and
199), a confirmation tone is heard. If it is not correct, an error tone is heard.
1
(5 sec.)
< 2 min
button for 5 seconds. The LED blinks once per second
button
button
button
2
Current no:12
0 1
moc beep
moc
2
If 9 is reached and the button is pressed
again, an error tone is heard. The next
button pressed starts off from number1.
3
2
beep
beep
moc
4
1 3